All ports commonly become inactive after a power cycle. The switch port often goes into the inactive state if the switch is configured as a VLAN Trunk Protocol (VTP) client with the uplink trunk port on a VLAN other than VLAN 1. Such a switch loses its VLAN database after a reset. As a result, the uplink port and other ports that are not members of VLAN 1 become inactive.
Perform these steps to resolve the problem:
Change the VTP mode temporarily to the transparent mode. switch (enable) set vtp mode transparent VTP domain CISCO modified switch (enable)
Add the VLAN to which the uplink port is assigned to the VLAN database. This example assumes that VLAN 3 is assigned to the uplink port. switch (enable) set vlan 3 VTP advertisements transmitting temporarily stopped, and will resume after the command finishes. Vlan 3 configuration successful switch (enable)
Change the VTP mode back to the client mode when the uplink port begins to forward traffic. switch (enable) set vtp mode client VTP domain CISCO modified where, 'CISCO' is the domain name.
When you complete these steps, VTP repopulates the VLAN database from the VTP server. All ports, which were members of VLANs that the VTP server advertised, move back into the active state.
I have BGP learned prefixes that I want to redistribute into EIGRP but with different metrics. I use a route-map with a "set metric +512000" (with or without the + sign) but that does not take effect... I still receive the same metric with the default red...
Greetings!,Hope you guys doing good.In my organization, I have following NAT rule configured.nat (TRPS-Inside,any) source static NET10 NET10 destination static NET10 NET10 no-proxy-arp route-lookupI am not able to understand its significance as I am still...
I was going to install the maintenance release for 3.5, I performed an ftp backup, and then I stopped NCS via ssh so that I could create a VM snapshot. When that was finished, I attempted to run NCS start, and that failed with the following me...
Hello all,New to Cisco, but trying to figure out exactly why my C3560-CX is having slow FTP performance. The switch is brand new, with barely any config, and I'm FTP-ing a new image file to upgrade the IOS. However, the transfer was painfully slow, and up...
On ASA 8.2 I am receiving bulk error notifications about 32K error messages in few hours for the syslog event ID 106006 The Message is as below ""Deny inbound UDP from 10.107.0.32/56506 to 10.113.13.67/514 on interface inside"" Someone please explain in d...