The Catalyst fixed configuration switch will not power on.
To resolve this issue, perform these steps:
If all LEDs (including the system LED) are off, make sure the power switch is on and that all the connections to and from the power supply are securely connected. Make sure the power outlet has power and that it is the right type of power. If the switch is connected to an Uninterrupted Power Supply (UPS) backup power source, plug the switch directly into the wall to eliminate the UPS as the source of the problem.
When the Power-On Self Test (POST) completes successfully, the port status LEDs go out. This indicates that the switch is operational. If a test fails, the port status LED associated with the test displays amber. The system LED also displays amber.
To see if any port failed a POST, issue the show post command on the Catalyst switch when the system is running. The show post command is available with Cisco IOS Software release 11.2(8.5) SA6 and later. This command checks to see if the POSTs passed. If there is a failure, it determines which POST failed. This command is useful when you are able to get a link on a particular port or the port LED is amber. For example, this output is from a Catalyst 2900XL, which failed a POST on FastEthernet interface 0/19:
2900XL# show post POST FAILED: FastEthernet 0/19 failed front-end loopback test
Failure of any of these diagnostic tests is normally non-recoverable and usually requires a Return Materials Authorization (RMA) to resolve the problem.
When I try to access the webserver from PC7 (see screenshot), I am given a "server reset connection" error. Upon checking the packet, I observed that the router RTR-1 is swapping the Destination IP address with the Souce IP address. Is there a way to fix ...
I've got a 2Mbps mpls link as a VPN 0 transport on a vEdge 100m. Carrier drops ALL traffic it receives above 2Mbps. I want to treat all traffic the same but simply want it to get across the mpls link and not get dropped. I thought I could accomplish this ...
HiI have configure a Router 2921 to act as NTP server for my network devices. It sinchronize with a Windows sever 2016 NTP but is not workng NODO1#sh ntp associationsaddress ref clock st when poll reach delay offset disp~IPSERVER .LOCL. 1 50 64 ...
I am trying to view "show version" output on a text file (.txt) using"show version | redirect tftp://22.214.171.124/show_version_output.txt"in the CLI, but I keep getting a Timed Out error. Any thoughts or advice on how I would be able to open "show version" on ...