Seeing temperature alerts as soon as booting of the switch.
%C6KENV-4-MINORTEMPALARM: module 9 asic-10 temperature crossed threshold #1(=90C). It has exceeded normal operating temperature range.
We could see multiple asics on the line card having high temperature values and had a thorough check on environment sighting its not just limited to a particular asic and mostly likely not a hardware issue with card.
However there was nothing blocking the air-flow or there was nothing wrong with air conditioning of the data center. Also slot covers were installed on all empty-slots.
The issue was resolved after removing blank slot cover and installing filler plates (WS-X6K-SLOT-CVR-E which simlar to a dummy line card) in empty adjacent slot as recommended per hardware installation guide.
Chassis Slot Filler Restrictions for WS-X68xx and WS-X69xx Modules
If you are installing one or more of the WS-X68xx or WS-X69xx modules in your chassis, the slots directly adjacent to these modules (above and below or to the left and to the right) must contain either another module or switching-module filler plates (Cisco part numbers WS-X6K-SLOT-CVR-E or SLOTBLANK-09). If either adjacent slot is unused and currently has a blank slot cover (Cisco part number WS-X6K-SLOT-CVR) installed, you must remove the blank slot cover and replace it with a switching-module filler plate for NEBS compliance.
Hope this helps if you ever encounter similar issue.
I try and read and help people on here, however....Surely there needs to be some sort of competence level before people are allowed to post?I see more and more posts that I just think FFS how have you even got a CCO account?My Cat 3850 won't route? Come o...
Hi, I am struggling with the setup of the WLC 9800 on a Catalyst 9300 Switch. I would like to configure it from DNA Center but I think DNA Center is not aware that I have one.Here is the output from my switch Next reload AIR license Level: AIR DNA Ad...
Hi all, I’ve been reading up and SPAN and the use of aggregator taps and full duplex taps. I feel i have a better understanding of each, but i still have a question that cannot seem find the answer to, hopefully somebody will know the answer to...
Dear All , I am doing my thesis on Segment Routing and trying to show the benefits of SR by using GNS3 and building a network and implementing SR and testing some use cases I'd need your help and suggestions the network is as shown below &n...
Hi All and thanks for any clues or solutions. First Issue My VPN setup seems to work ( Connects fine to my Iphone and Ipad) even with some issues in the log !! ?? Should I just ignore those ?? %CRYPTO-6-IKMP_MODE_FAILUR...