The router may get stuck in a continuous loop, which may be due to a hardware issue. A continuous loop never lets you gain access to the router. The router continues to scroll error messages until it is powered off.
These symptoms may be observed on the console during the boot sequence:
Not enough memory in the system for IO memory
IO memory available 4110105 required 5242880 _> 2600
SYSTEM INIT: INSUFFICIENT MEMORY TO BOOT THE IMAGE!
I have a cisco ucs c200 m2 server which installed Esxi 6.7 on it.Server's network stops every day and the only way to have it online again is restarting the server. I've even got KVM access from datacenter and tried to restart just the network of it but i...
Hello all,I am curious as to whether cisco has an official topology for CCNA and CCNP. If so, where can I find this information. If not, are there any suggestion for other topologies to use. Thanks,Dave C
Hi everyone, I'm having some trouble with output drops that maybe someone would be kind enough to check over for me. The map for this section is here https://imgur.com/a/baPYoxb I have 2x 2960 connected to 2x Nexus 3500 via 4x Fibre, as I m...
Hello, I am trying to configure on a Catalyst 1000 switch a DHCP Server on network 192.168.1.0/24 with a fixed IP address of 192.168.1.10 for a PC Network with a specific MAC address. Here is the steps I followed :1) Type commands on Switchconf ...