The Versatile Interface Processor (VIP) card model VIP2-10 and VIP2-15, and the Fast Ethernet Interface Processor (FEIP) card models CX-FEIP2-2TX and CX-FEIP2-2FX require 16MB of memory when used with Cisco IOS Software Release 12.0 and later. If only 8MB of memory is installed, the card fails to boot up. A memory upgrade is required when upgrading to Cisco IOS Software version 12.0 or later.
When only 8MB of DRAM is installed in one of these cards, and the router is running Cisco IOS Software version 12.0 or later, issuing the show diag command produces an error message similar to this:
This is due to the microcode for Cisco IOS Software Release 12.x requiring more DRAM than the microcode for Cisco IOS Software Release 11.x.
If after upgrading a Cisco 7500 series router from Cisco IOS Software version 11.x to version 12.x, the VIP2-10, VIP2-15, CX-FEIP2-2TX, or CX-FEIP2-2FX card does not come up, issue the show diag command.
Check for the SYSTEM INIT: INSUFFICIENT MEMORY TO BOOT THE IMAGE! error message.
If the message is present, the card has only 8MB of DRAM. An upgrade kit must be installed for the card to work with the code of the Cisco IOS Software version 12.x.
Hello CISCO Community. I have an idea but I am not sure if I am just limited in the IOS to make this work or if there are any other technologies / configurations to make it happen. Basically, I am connecting two switches together with 2 links a...
Hi Guys, Got a strange issue between our core switch SX550-48 to our edge switch SX350-48. We use 4 copper links between the edge and core in a single port channel. The core switch shows all physical links up but the edge side is down. Not sure what ...
Something very strange started happening. I'm looking for a sanity check. We currently use a Radius-As-A-Service to provide authentication for our VPN on a Cisco ASA and ASDM access to that same ASA. Nothing changed on the radius side at all.&nb...
We see this issue quite often, we're staging an MSTP deployment of an NCS2006 M6 with dual TNC-Es, and we constantly lose connection to the shelf in CTC, making it difficult to setup some initial configuration parameters. This issue occurs on multiple she...
Hi, I want to make a PBR with asa 5520 with ios 9.1.x, but I can not put the set ip next-hop command Configuration aclaccess-list acl-pbr-dmz extended permit ip host 22.214.171.124 anyPbr configuration route-map pbr-dmz permit 10match ip addr...