The Gigabit Ethernet interface of the Catalyst 2960 series switch fails in the PortPhiLoopback Packet Test of the power-on self-test (POST). This problem is observed in a Catalyst WS-C2960-48TT-L that runs Cisco IOS Software Release 12.2(25)SEE2.
These POST messages can appear:
POST: PortASIC Port Loopback Tests : Begin POST: Failed PortPhiLoopback Packet Test asic_index 1 port_hardware_index 0 POST: PortASIC Port Loopback Tests : End, Status Passed
This issue is documented in Cisco bug ID CSCsg33994.
In order to workaround this issue, hardcode the speedcommand to 100 and theduplex command to Full on the affected ports.
In order to resolve this issue, upgrade to Cisco IOS Software Release 12.2(35)SE or later, which can be downloaded from the LAN Switching Software page.
Hello, I have a network were all traffic should pass through a firewall (in a server) that implements some routing and filtering rules. As we can see in this picture, the server is connected to switch 3 (a layer 3 switch). To direct the traffic to th...
I have a little problem of all Routers from area 22 (Except ABR),when it try to ping something out of its area, it gets into a loop between R5 & R6 & SW5, I guess its something about the cost of them but ill be glad for people to explain what is t...
I have two Cisco C6832-X-LE connected by switch mode virtual. Both switches are currently running 6848x-ipservicesk9-mz.SPA.152-2.SY1.bin and I would like to upgrade them to c6848x-ipservicesk9-mz.SPA.155-1.SY7.bin. What I am look for is th...
Hi,I was asked to implement this: 2 firewalls HA connect to 2 Internet circuits for redundancy trough switch either catalyst or small business switch SG- 500/300/250. I dont like this not-standard setup and I'd connect firewalls directly to the ISP ...
Hi, we are trying to get visibility into traffic at our remote site using netflow on a 9500. This remote site core switch has many VLANs and attaches to many 9300 access switches via trunks. All routing for the site is on the 9500. Traffic from and t...