The %C4K_HWPORTMAN-4-BLOCKEDTXQUEUE:Blocked transmit queue HwTxQId[dec]on[char], count=[dec]error message is generated on a Cisco Catalyst 4500 series switch when connected to a device. This error is a rate-limited message that indicates a transmit queue blockage on a port.
In this case, the traffic on the affected port is limited and blocked for reasons other than being paused. This blockage can occur if the supervisor is not able to send packets to the line card because a busybit message is received. In this situation, blocked transmit queue messages are seen. A bad hardware or speed and duplex mismatch can cause this problem.
Perform these procedures as a workaround for this issue:
Issue the shut /no shut commands to recover the port and configure both ends to operate at the same speed and duplex, as per Cisco bug ID CSCsb62330.
If the problem persists, move the connected device to another port and see if the problem also happens there.
Issue the hw-module reset command to reboot the switch or reset the line card, as a final attempt to unblock the Transmit (Tx) queue.
Alternatively, upgrade the the Cisco IOS version to the 12.2(25)EWA2 and 12.2(25)SG releases, which have the fix for this problem, as per Cisco bug ID CSCsb01311.
Hello,I was wondering if there is a way to monitor the packets going through specific ports or IPs on the Switch.MORE INFORMATION:We have a PTP GM200 clock setup broadcasting a PTP signal at 192.168.1.231, we are using an Emergent Camera at 192.168.1.110 ...
HiThis switch has 16 1/10 built in ports plus an 8 port uplink module.Can anyone please tell me the interface numbering convention here?ie te1/x (built in ports) and te2/x (module) or something else???ThanksSpecs:Catalyst 4500-X switch chassis with:16 1G ...
Hello, this might not be possible but wanted to ask. We have a bunch of hotels that all have a "interface server" that resides on the same subnet as the computers for the back office. We are wanting to move this interface server to a data center instead o...
This question has been asked in this discussion, but the post has gone stagnant without resolution...I have an old static route configured on my IRS4321k9 that I put in during testing. Now that the router is deployed, I want to remove the old route but it...
Hello, I'm trying to setup eBGP between my on premise routers (RTR A/RTR B) and Firewall (Palo HA) pair hosted in AWS. On premise devices (RTR A and RTR B) connect to AWS cloud router (RTR C) via Megaport connections (2 /30 point to point netwo...