The %C4K_HWPORTMAN-4-BLOCKEDTXQUEUE:Blocked transmit queue HwTxQId[dec]on[char], count=[dec]error message is generated on a Cisco Catalyst 4500 series switch when connected to a device. This error is a rate-limited message that indicates a transmit queue blockage on a port.
In this case, the traffic on the affected port is limited and blocked for reasons other than being paused. This blockage can occur if the supervisor is not able to send packets to the line card because a busybit message is received. In this situation, blocked transmit queue messages are seen. A bad hardware or speed and duplex mismatch can cause this problem.
Perform these procedures as a workaround for this issue:
Issue the shut /no shut commands to recover the port and configure both ends to operate at the same speed and duplex, as per Cisco bug ID CSCsb62330.
If the problem persists, move the connected device to another port and see if the problem also happens there.
Issue the hw-module reset command to reboot the switch or reset the line card, as a final attempt to unblock the Transmit (Tx) queue.
Alternatively, upgrade the the Cisco IOS version to the 12.2(25)EWA2 and 12.2(25)SG releases, which have the fix for this problem, as per Cisco bug ID CSCsb01311.
Hi All I have build my SWAN lab in eveng just to practice some basic stuffs . I am trying to install manual certification in vbondthrough xca , but i am encountering this error every time . I am using quite old IOS 16.2....
Hello,I would like to restore running-config and vlan.dat on a cisco 3850 switch.I have the old configuration on a txt file.On the switch, I have the startup config file in the nvram folder.On the other hand, the vlans do not appear in the conf, they are ...
Hey guys, currently looking into network management and monitoring solutions for a network containing both cisco and ciena network devices. We've seen both company's vendor specific management software (Prime Infrastructure and One Control), but I'm looki...
Hopefully this can be done. I have tirelessly looked through the forums and tried to see if others can do the same and tried different configs but no go. Here is what I am trying to do.I have a USG Router with 2xWAN ports and 1xLAN port WAN1 = ...
Hello. Can you help me. How the PC ping the router interface. The PC able to ping the vlan 701 interface in the SW. How do I get the PC to ping the router interface? Below the configs swich and route: ********SW*****************************...