The %C6KENV-SP-2-FANUPGREQ: Module [dec] not supported without fan upgrade error message indicates that the supervisor engine and the Distributed Forwarding Card (DFC) in the specified slot require a fan tray upgrade.
A compatibility problem with the supervisor engine installed and the fan tray. The supervisor could require a high-speed fan tray.
The fan trays are mis-seated.
The fan tray is damaged.
Depending on the root cause of the problem, perform one of these steps in order to resolve the issue:
Refer to the Fan Trays section of Release Notes for Cisco IOS Release 12.2SXF on the Supervisor Engine 720, Supervisor Engine 32, and Supervisor Engine 2 for more information about supervisor engine and fan tray compatibility on Cisco Catalyst switches running Cisco IOS Software.
Hi all, how can i block snmp and ntp ports on my Public L3 switch Cat 4506e?I have multiple interfaces as router interfaces and on all of them are these ports open.How can i block them from the piblic internet and allow only from my local netwoks IP ...
I try to repost here one of my posts that found little response ... I need to extend some VLANs between two location (the Enterprise DataCenter and a remote DR DataCenter).The obvious solution is using OTV between two CSR1000v's.The connection I have...
Hi,When I first try to manage a network that is connected the following error message appears: Unable to reach the server. Why? See pics attached about the error message and about the related network connection.Username: webuiPassword: ciscoThx!
To participate in this event, please use the button to ask your questions
* Note: The link to join the discussion will be activated on March 8
All the knowledge of these four experts at your disposal!
Cisco Software-Defined Wide Area Network (SD-WAN...
I would like to detect when the result of a command, its output is missing.The output is missing due to the failure of cellular SIM card. All parameters on the SIM card will be missing. Examples:command - show cell 0 hardware | inc Digital Network-Nu...