The C6KPWR-4-DISABLED: Power to module in slot [dec] set [chars] error message indicates that the module in the indicated slot was powered off for the indicated reason. [dec] is the slot number, and [chars] indicates the power status.
Along with the previous error message, the logs can display the %ONLINE-6-TIMER: Module [dec], Proc. [dec]. Failed to bring online because of timer event error message.
This means that the system is not able to download the runtime image to the module or processor because the download or ASIC initialization did not complete in the allocated time.
For further assistance and support, use the TAC Service Request Tool in order to open a service request with Cisco Technical Support.
i am confused policing drops data that exceeds the set amount in bandwidth, and can resend data but shaping slows down data and can resend data ? I Was reading the Cisco cert guild can you apply shaping and policing on the queues?
Hi, I´m planning implement private vlan for all switches on network, 15 switches on all network ( there are 15 floors separetd by vlan 1-15). The purpose is block the hosts communicate each other on same network. I dont have ISE to implemment the bes...
Hi, I am trying to utilize DLEP with the EIGRP routing algorithm. If I query the system with "sh dlep neighbors," I see the correct CDR(Current Data Rate) for two radios connected with DLEP to the router, one having a data rate half of the other...
Hello everyone, I'm doing a review of some Cisco devices (switches and routers) and one of the questions I need to respond to is the date when the last patch was applied to the devices. Is there a way I can determine that from the equipment?
Hi there, I would like to use IP SLA UDP Jitter to alert when the MOS score is greater than 3.5. My config: ip sla 2udp-jitter 188.8.131.52 5000 codec g711alawtos 184threshold 60timeout 500frequency 15history hours-of-statistics-kept 1history en...