In this case, Cisco Express Forwarding (CEF) is disabled due to a low memory condition. If the ip cef [distributed] command is configured, CEF can be re-enabled.
Cisco recommends the reduction of other system activity in order to ease memory demands. If conditions warrant, upgrade the Route Processor (RP) so that it contains more DRAM.
In some scenarios, flushes on the input queue of an interface relates to full buffers.
This can be explained as a packet arrives on the interface and is received by the local controller, the interface driver receives the packet and checks for basic data integrity, if buffers are available the packet is processed normally. If there are insufficient local buffers available, the interface driver tries to allocate space from the public particle pools in DRAM/SDRAM. If there are no free buffers available in the public pool, the interface drive flushes the frame and increments the ignore and no buffer counters.
If the router is unable to forward the packet with fast/CEF switching, the buffer particles are coalesced and the packet is placed into a system buffer for process - switching. The packet is now enqueueed and the interface hold queue is incremented. If the hold-queue is full, the packet is discarded, and the input queue drop error is generated.
The %FIB-2-FIBDOWN: error message can occur due to these reasons:
Reason 1: When the number of not-directly connected routes that the desktop default template allows is exceeded, this error message can be received. If this template is used, it is likely that the maximum number of 2000 is exceeded.
Reason 2: When the number of MAC addresses learned by the switch has exceeded the amount of space allocated in hardware to store MAC addresses, this error message can be received. In this case, the show mac-address-table count output shows 0 free entries.
Reason 3: If the Catalyst 3750 experiences a memory leak in the IP Routing Information Base (RIB) update process, this error message can be received. The process begins to hold more and more memory, and does not release it.
Try these workarounds based on the reasons stated in the Core Issue section:
Workaround for Reason 1: Issue the sdm prefer routing command and reload. Ideally, this resolves the problem.
Can the bootflash memory on a 3172PQ be increased? Our company has the model that has 2 gig bootflash. We are patching from 7.0 to 9.3 and t here is not enough space to store the 9.3 IOS for the upgrade. I am familiar with# copy scp&n...
I have a device , a MS Surface tablet with a docking station that could get DHCP info with valid IP and gateway, etc, but would not ping anything on the docking station ethernet port, but would get an IP and surf with it's wifi and with a USB to ethernet ...
Sharing a recent experience we encountered while upgrading our DNAC cluster. Our upgrade was from 188.8.131.52 directly to 184.108.40.206. The error we were seeing in the maintenance UI was specifically: Phase:Node x.x.x.x - Backup NFS server mount failed
The CLI err...
I have a C1101-4p that keeps skipping a static IP/port mapping when it reloads. Please see example of the line below ip nat inside source static tcp x.x.x.x 443 x.x.x.x 443 extendable This is the first line of the static mappings. It will load t...
I am now sitting on two verizon models. I had a "V" model and I last ordered a At&t model from a company in MN and they sent me a verizon model accidentially. When I told them they said they would refund me and they do not have a "A" model in stock an...