This error occurs when the Spanning Tree Protocol (STP) debug is on. These messages are cosmetic and occur when you have either bridge groups or VLANs. This is caused by the specific debug spanning tree exception and can be ignored.
This issue is documented in Cisco bug ID CSCdt71887.
Ignore these messages:
Externally found moderate defect: Resolved (R)
Bridge group no free chunk available
The feature these messages refer to (optimized BPDU transmission for switch VLAN spanning trees) is not used by the bridge group.
I am trying to figure out an issue with Small packets (sub-200Byte) which caused firewall performance issue and so far I can only pin point to the 4507 LAN switch doing the fragmentation...Standard MTU1500 is in use though. From "show ip traffi...
Two tunnel is configured on a router the source and destination of the tunnel is on one destinationAnd we have one vrf That one of these tunnels inside to vrfAnd dynamic routing configure On two tunnelsBut one of tunnel down then when configure mode ipip ...
Hello everyone, I'm practicing in a 2960 with Packet Tracer. I wanted to test virtual lines access with ssh version 2.I tried setting from 2 to 10 with #line vty 2 10 and it doesn't work. I'm asked about password, but I never log in, even w...
This issue just started. I am no longer able to log into my switch via a web browser. Credentials are correct. It worked fine last month. Tried using different browsers. Keeps telling me invalid username or password. I'm using the same o...
Muy buenos dias.En este caso molesto por algo que deberia ser sencillo, pero no funciona.Tengo un Router con 2 interfaces ETH conectadas y configuradas en redes distintas, y una ruta estatica por default.El tema es que de a red B no puedo llegar a la red ...