When the VLAN Trunking Protocol (VTP) mode is changed from VTP client mode to vtp transparent mode, the service providers loose Open Shortest Path First (OSPF) capabilities, but the IP connectivity is unaffected. The OSPF announcements becomes uni-directional.
The VTP transparent mode is needed when you want to configure an extended VLAN on the switch.
In many scenarios, this issue is due to VTP pruning enabled on the VTP server and thus, this impairs multicast hellos.
Try this workaround in order to resolve this issue:
Change the OSPF network type and hardcode neighbor statements into ospf config.
Issue the no vtp pruning global configuration command in order to disable VTP pruning in the domain.
I am currently working on a Cisco SD-WAN deployment with cEdges. Each site has a single router with a MPLS TLOC and a Biz-Internet TLOC. I am attempting to get control connections from my MPLS Tlocs up. I have advertised a default route ...
On my Nexus 6K I see that the interfaces patched to the Cisco UCS regularly show discards but not errors. These are10Gbps links w Copper SFP-H10GB-CU3M. The links are never close to capacity. The ratio over time appears to show .001 (1/10 of 1%) of d...
Hi.We have ESXi hosts that use Dell 3800 storage.At the moment it connected directly (1G copper) and set up using iSCSI protocol.We have decided to change the topology and connect ESXi hosts and the storage using Cisco SX350X switches.So the problem is wh...
Hi All, I have recently installed two Prime 3.9.1 appliance setups. During the install i didn't select one of them to be used as a secondary. Will i be able to join them in the HA option via the GUI? or is there steps for me to fix this without rebui...
Hi,a Line Card WS-X4748-RJ45-E in Slot 5 of Cisco C4506 Chassison 21.06 - Module went offline and we did manually removed the line card and inserted it again, then the module was running for about 60 minutes again, but failed again and was shown as 'Offli...