Hi Guys, I'm struggling with an issue connecting a Watchguard to a Cisco via IPSEC. I've managed to establish the VPN - however i get no traffic through it. I know I'm missing a route, like "ip route 10.33.0.0 255.255.255.0 10.0.0.253 ... view more

Hi,I am trying to send netflow data to collector server through ASR1006 Gig0 interface.Gig0 is in vrf Mgmt-intf Unable to see data in collector server  Below is configuration : flow record Record_NFAmatch ipv4 protocolmatch ipv4 source... view more

Dears,Scenario is IPsec tunnel is already established in VPN 0 and also we have  loopback created in VPN 0 which we want to forward through IPsec tunnel because though this loopback NMS system will access vEdge.and a default route pointing towar... view more

Hi, is there a list of alarms and corresponding severity for ASR 903?What I need is which alarm trigger critical severity alarm, or which one trigger Minor or Major and so one.

If we running urpf under one interface and config this interface as source interface in one monitor session does traffic get sniffer to wireshark wheather traffic hit URPF or not？