The Cisco Catalyst 2940, 2950, 2955, 2970, 3550 and 3750 switches are not accessible from a router for IP address configuration.
If the switch cannot be accessed, the management VLAN interface (VLAN 1 is the default management VLAN interface) may be shutdown or does not have an IP address assigned to it.
If the VLAN interface is shutdown, perform this procedure:
Attempt to connect to the switch with a console cable.
Configure the VLAN interface.
Verify that the management VLAN interface is properly IP addressed and not in a shutdown state. If the interface is not properly IP addressed or in a shutdown state, proceed to the next step.
To bring a shutdown VLAN interface up, issue the no shutdown command in VLAN interface configuration mode.
To configure an IP address to the interface, issue theip address command. Note: This command can ping the switch from the router.
If the switch is accessed from a Web browser and the Cluster Management Suite (CMS) does not launch automatically, the installation of an unsupported Java Plug-In is a possibility. If the plug-in is not enabled, this can also interrupt the CMS launch.
To enable the Java Plug-in or verify that it is enabled, click Start > Settings > Control Panel > Java Plug-in. Then, click the Basic tab, select Enable Java Plug-in and click Apply.
If it is not possible to ping or Telnet access the switch from other hosts in the LAN, but it is possible to ping or Telnet from the primary router, issue the ip default-gateway ip-address command to configure the default gateway. Enter the IP address of the next-hop router interface that is directly connected to the switch where a default gateway is being configured. The default gateway receives IP packets with unresolved destination IP addresses from the switch.
Note: When the switch is configured to route with IP, it does not need to have a default gateway set.
Hi all, I have an issue that I am trying to resolve. I have a Nexus 7k and I am trying to build an EEM script to send a syslog message to a syslog server when an IP SLA track goes down. I can verify through show event manager events action-log t...
I have a 3850 acting as a layer 2 switch with a brand new IP phone connected to it. The L2 3850 is connected via ethernet to another 3850 which is acting as our layer 3 gateway. Both of these devices can ping the phone and the DCHP server does see the pho...
Hi Guys, I am new to networking. I am studying from last two weeks about networking. I tried everywhere, but I am confused with IP addressing. Please check the below examples and suggest the correct answer. Sorry if you find this stupid:). 1) Network...
Hi community I am planning out a new network and have before just used a single router as a solution but I need some redundancy. So I'd like to setup two ASR 1001-X routers. I have an ASN and IP block assigned to me. I am peering with one ...
Good morning,I've an IE-3300 series hardened network switch we are using in an unconfigured state currently to create a temporary LAN for our controls system. After a shutdown, we powered the switch back up, and didn't have any link or connectivity ...