In the Cisco Catalyst 6500 switch running in native Cisco IOS® 6509, configured to allow only Secure Shell Version 2 (SSH2) connections, it is not possible to Telnet out to a non-SSH switch or router. Also, the session command cannot be issued in order to access a module in Cisco Catalyst 6500 switch. The Command Line Interface (CLI) prompt shows that "telnet" and "session" are valid commands.
The only workaround for this issue is to connect to the Cisco Catalyst 6500 switch through the console port. This can be done remotely with a console server.
Telnet attempts display the % telnet connections not permitted from this terminal error message and after few attempts, the module number is flagged as invalid. This happens because the VTY (Telnet) is misconfigured as transport output none.
The configuration looks similar to this one:
line vty 0 4
exec-timeout 60 0
transport input ssh
transport output none
flowcontrol software out
In order to resolve the "telnet out" and "session to the module" issue, configure the transport output command for the required protocol.
Good afternoon with everyone, the consultation is up to one hundred point very basic. I have a platform of Routers ISR2 3945, and also ISR1 2825 and 2811, now I have added a Router 4400, in all routers I can get backup of the configurations, via TFTP, exc...
Not sure if I am missing something or what.....From the netflow MIB, I am trying to poll the object 184.108.40.206.220.127.116.11.318.104.22.168 to get statistics.this works fine with the 19/29/3900 series. It returns a zero on all of our ISR4ks. If I issue "sho flow exp st...
Link doesn't come up. Nexus 3548=========Ethernet1/1transceiver is presenttype is 10Gbase-LRname is SXXpart number is SFP-10G-BXrevision is --serial number is C1909234024nominal bitrate is 10300 MBit/secLink length supported for 9/125um fiber is 10 k...
I would like to enable SGT based policy between Virtual Networks based on SGTs. The fusion device is a 9300s switch and I understand I have two options: 1. SXP between the fusion device and ISE to receive IP to SGT mappings + Enable Enforcement of th...