i install gns3 on my windows 7 pc , i have no issue with it, except when i try to configure sdm i always fail.
here is the step which i did
router series =7200 (c7200-advipservicesk9-mz.124-2.T.bin) ip address 192.168.10.1 255.255.255.0 ip http-server
ip http-secure username xyz password abc
[I m using virtual pc with my router ]
vpc 192.168.10.2 24 192.168.10.1
after that i can successfully ping my router and my vps with each other , but when i launch SDM and give the ip address of my router after that i m unable to connect with my router it also doesnt ask username and password, i dont know what i am doing wrong. plz see my attach for detail
Hi EveryoneI am facing issue on CISCO 2921 Router since last week. Router keep on rebooting automatically. Find below details of Show commands output. Appreciate if anyone can guide about the root cause of Router rebooting. There are no configuration chan...
Hello Expert,I have two cisco router in HSRP configuration.On each router I have a 4 port card.The vlans configured on the card (both primary and secondary router) are Production Telephone,Security vlan.I am to configure an use HSRP on the production vlan...
Hi Team, Is there cisco recommend RSTP to MSTP migration procedure ? I didn't find any cisco related document for this. Currently network consist of Core (6500 Series) Switches, distribution (4500 series) switches and Access (3850, 2960X an...
Hiat first i want to say that am a newbie in networking and i come from germany so my englisch is not the best.So, here is my Problem: I have a Server at home for general purpose and the home lan i share with my family.My router is a Fritzbox 7490 an...
Hello.I'm having an issue with SSH console slowness once connected into a network device on GNS3. It generally slow on any router/switch regardless of the configuration to ssh/vty lines.If using Telnet it's perfectly fine and very responsive but ssh is sl...