i install gns3 on my windows 7 pc , i have no issue with it, except when i try to configure sdm i always fail.
here is the step which i did
router series =7200 (c7200-advipservicesk9-mz.124-2.T.bin) ip address 192.168.10.1 255.255.255.0 ip http-server
ip http-secure username xyz password abc
[I m using virtual pc with my router ]
vpc 192.168.10.2 24 192.168.10.1
after that i can successfully ping my router and my vps with each other , but when i launch SDM and give the ip address of my router after that i m unable to connect with my router it also doesnt ask username and password, i dont know what i am doing wrong. plz see my attach for detail
Hi; I've configured Xconnect over MPLS Cloud between 2 sites Xconnect is showing up but there is no reach-ability between the 2 sites from LAN your help R1 (ISR 4321)pseudowire-class R1encapsulation l2tpv3ip local interface Loopback100inter...
i have switches already configured with snmpv3 and i need to move the configuration to other switches and have some understanding of the commands: 1-does "access snmplist" is an access-list that points to the server which is using the snmp like solar...
Is it possible to configure a group on ports in an untagged VLAN to pass 802.1x authentication between themselves? For example, a device in VLAN 99 on port 10 perform 802.1x authentication with a device in VLAN 99 in port 11?
What does below error indicate ? Currently all modules diagnostics is showing passed. WS-C6509-E VS-SUP2T-10G In VSS15.1(2)SY10 r2d2_test_one_scratch_reg16:test faile reg[0x0]r2d2_test_one_scratch_reg16:test faile reg[0x1]r2d2_test_one_scratch_r...
Hi all,I am using my core switch cisco 4500E as NTP server for CUCM servers . the core switch sync its time with WAN firewall by stratum 6 which makes the core switch as stratum 7 for CUCM servers and this is not accepted.how to make the core switch...