A Bad memory - wrote zero, read 0x00040000 at location 0x00000010 error message is displayed either at boot or after the router has been running for a short period of time. This error message occurs in routers that do not check memory while loading the Cisco IOS Software.
Open the chassis and reseat all DRAM SIMMs.
For information how to reseat DRAM SIMMs, type Installing and Upgrading DRAM SIMMs into the TAC Advanced Search to find information about the router on which you wish to reseat memory.
If the problem recurs, the memory is faulty and needs to be replaced.
When hardware replacement is indicated after troubleshooting, perform one of these options:
If you have a hardware support contract directly with Cisco for this part, refer to the Service Order Submit Tool to request a replacement part directly.
For warranty service, contact the Cisco Technical Assistance Center (TAC) directly at 1-800-553-2447, or online by referring to the TAC Service Request Tool.
If your product is not covered by contract or warranty, contact your Cisco partner or reseller to request a replacement part for the hardware component that is causing the issue.
Hi I am trying to monitor the Cisco DNAC node health status using the monitoring capabilities (System > System 360 > Monitoring) comes with Controller. Like to trigger an alert (Grafana alert) if the node is unhealthy and not part of the ...
Hi all, I have an ASR901 that is showing as "Down" from my Solarwinds server. From my server, I can putty into the device but I cannot ping it. If I do a "debbug ip icmp" I can see the router showing this:ICMP: echo reply rcvd, src 10.2.2.90, ds...
Greetings. (Sorry for my english)A few days ago I purchased from eBay a used 2901 router.The router came with only two built-in connections (g0 / 0 g0 / 1) with no ehwic extensions.I connected the router to a home router that provides a 1gbps fiber connec...
Hi,I have problem with power consumption of switch Cisco Catalyst 2960S-48TS-L. There is max. consumption 52W in 100% utilization in datasheet, but I measured 90-100W power consumption with no load. Problem is that UPS time of this switch is half of assum...