The issue is caused by the modular port adapter not being recognized by the software or when the hardware revision of the port adapter is either too low or not supported on the Cisco 7200 VXR series router.
This is an example of the error message of a port adapter not recognized by the Cisco IOS Software:
OIR-6-INSCARD: Card inserted in slot 1, interfaces administratively shut down
%PA-2-UNDEFPA: Undefined Port Adaptor type # in bay #
%PA-3-DEACTIVATED: port adapter in bay [#] powered off.
This is an example of the error message of a port adapter not supported with a Cisco 7200 VXR series router:
00:00:28: %OIR-6-INSCARD: Card inserted in slot 1, interfaces administratively shut down
00:00:29: %PA-3-NOTSUPPORTED: PA in slot1 (Channelized T1) is not supported on this chassis
00:00:29: %PA-3-DEACTIVATED: port adapter in bay  powered off.
00:00:29: %PA-2-PABRIDGE: Failed to config bridge for PA 1
In both port adapter error messages, the port adapter is shown as disabled in the show diag command output, as shown in this example:
Router#show diag 1
Channelized T1 port adapter, 2 ports
Port adapter is disabled unsuitable deactivated powered off
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.1 Board revision A0
Serial number 5105485 Part number 73-1565-05
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 07 01 01 00 4D E7 4D 49 06 1D 05 00 00 00 00
0x30: 50 00 00 00 97 05 31 00 FF FF FF FF FF FF FF FF
Dear All ,I have two stack switches ( WS-C3850-24S ) with SW version 16.3.6 , one of them stuck in boot ..( please find the snapshot)I search for the error and it's seem i get cisco Bug CSCuv75864Can you please help me with the solution steps to fix this ...
Hi guy.We have config Fex for Nexus c2348UPQ and Nexus 7706. But we have problem.When we config, physical connection plug in : Port 1 and port 2 ( Picture 1).But when config complete, we using: Sw01# show interface fex-fabricFabric Fabric Fex FEXFex ...
Hello guys, I wanted to create an equivalent of a leased line for my home lab using two serial cables a (DTE) cable and (DCE) cable. I have two 1921 Cisco routers and realized they didn't come with serial WAN interface cards. I did some searching and...
We did a upgrade last week to the version 16.6.4a ( WS-C3850-24XS-S) and since that upgrade we had several log: Sep 18 14:44:01.285 EST: %SNMP-3-RESPONSE_DELAYED: processing Get of entSensorValue.1124 (17248 msecs)Sep 18 14:53:49.247 EST: %SNMP-...