The Redundant clock failed message on a Catalyst 6000 series model indicates clock module failure. If the clock module fails, it is impossible to change from a primary clock to a standby clock.
The clocks are located on the chassis. To resolve this issue, find a hardware replacement for the clock module.
Perform one of these options:
For warranty service, contact the Cisco Technical Support directly at 1-800-553-2447 or online by using the TAC Service Request Tool.
If you have a hardware support contract directly with Cisco for this part, open a service request online by using the TAC Service Request Tool. After opening the service request use the Service Request Query Tool to request a replacement part directly.
If your product is not covered by contract or warranty, contact your Cisco partner or reseller to request a replacement part for the hardware component that is causing the issue.
Dear all, As for attached image, I have to force traffic to a shaper node that working like bridge. I have also to put in place an OSPF session to redistribute routes from RTR-01 to RTR-03. From your point of view, is it a good idea ?...
Hi We have installed the GPRS card and Vodafone 2G SIM Card in the router. We have done the GPRS configuration but GPRS is not coming up. Details are mentioned below PID: CISCO1921/K9 PID: HWIC-3G-GSM IB_1616_KNL_IMT_MANESAR#sh cellular 0/10 /0 al...
Hi Tech Guys, Could you share some guide about calaculation Oversubscription ratio between Access to Distribution and Distribution to Core,For example for Cisco 9400 per slot capacity is 80Gbps and and how can we use 24 Port 10G Moudule which i...
good day. ISR 4351/K9 IOS 16.09.04 i need to make "ip nat inside source static" for range 5100-5200 tcp ports. i have find code, like next: ip access-list extended 190permit tcp host 192.168.0.10 range 5100 5200 any!route-map MAP_RST permit 10m...