This document contains the slides for the Webcast.
The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and four 1G Small Form-Factor Pluggable (SFP) or two 10G SFP+ uplinks. With FlexStack-Plus technology, the Cisco Catalyst 2960-X switches can be stacked up to 8 members with up to 80 Gbps stacking capacity for high scalability. During this presentations, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
During this presentation, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
Comparison and differences in Cisco Catalyst 2960-X and 2960-XR Series Switches
Flex Stack Plus in 2960X/XR
Overview on various features on the 2960X/XR
Troubleshooting best practices and hints
Roopa R. is a Technical Leader in Enterprise Access Switching group at Cisco. She is an expert on Forwarding – Layer2/Layer3, QOS, Security, AVC, Netflow, and Wireless technologies and products. Roopa holds a Bachelor’s Degree in Electronics and Communication Engineering from Bangalore University and a M.S. in Software Systems from Birla Institute of Technology and Science in India. Roopa has 17 years of experience in IT and has been working at Cisco for 9.5 years. Prior to Cisco she worked at Lucent Technologies and Sasken Communication Technologies.
Join the Ask the Expert discussion at Get answers before opening a TAC case by visiting the Cisco Support Community.
Could any of you please tell me why I don't see the bridging related commands on IOS XE 16.6.6 (C1116-4P, IP Base) ? C1116-4P(config)#interface Ethernet0/2/0
% Unrecognized command
Good afternoon with everyone, the consultation is up to one hundred point very basic. I have a platform of Routers ISR2 3945, and also ISR1 2825 and 2811, now I have added a Router 4400, in all routers I can get backup of the configurations, via TFTP, exc...
Not sure if I am missing something or what.....From the netflow MIB, I am trying to poll the object 22.214.171.124.126.96.36.199.3188.8.131.52 to get statistics.this works fine with the 19/29/3900 series. It returns a zero on all of our ISR4ks. If I issue "sho flow exp st...
We would like 10.0.1.0 to go out over ISP1 and fail to ISP2We would like 10.0.2.0 to go out over ISP2 and fail to ISP1This simplified, there are a ton of networks for each. Is this the right method?object network obj_10.0.1.0_PRIMARYsubnet 10.0.1.0 2...
Link doesn't come up. Nexus 3548=========Ethernet1/1transceiver is presenttype is 10Gbase-LRname is SXXpart number is SFP-10G-BXrevision is --serial number is C1909234024nominal bitrate is 10300 MBit/secLink length supported for 9/125um fiber is 10 k...