This document contains the slides for the Webcast.
The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and four 1G Small Form-Factor Pluggable (SFP) or two 10G SFP+ uplinks. With FlexStack-Plus technology, the Cisco Catalyst 2960-X switches can be stacked up to 8 members with up to 80 Gbps stacking capacity for high scalability. During this presentations, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
During this presentation, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
Comparison and differences in Cisco Catalyst 2960-X and 2960-XR Series Switches
Flex Stack Plus in 2960X/XR
Overview on various features on the 2960X/XR
Troubleshooting best practices and hints
Roopa R. is a Technical Leader in Enterprise Access Switching group at Cisco. She is an expert on Forwarding – Layer2/Layer3, QOS, Security, AVC, Netflow, and Wireless technologies and products. Roopa holds a Bachelor’s Degree in Electronics and Communication Engineering from Bangalore University and a M.S. in Software Systems from Birla Institute of Technology and Science in India. Roopa has 17 years of experience in IT and has been working at Cisco for 9.5 years. Prior to Cisco she worked at Lucent Technologies and Sasken Communication Technologies.
Join the Ask the Expert discussion at Get answers before opening a TAC case by visiting the Cisco Support Community.
Hey, My project contains five different networks and my task is to connect them via RIP. Each network has a PC connected to it. My goal is to be able to ping every PC from each PC. I've already tried to add the different network addresses to Ro...
Dear all, I appreciate if you can let me know your feedback, in my opinion actually Cat3K can support limited layer 3 static routingon Stackwise with LAN base feature right? however if I have been investigating with CCO there is following information...
I have a Windows Server 2016 DHCP setup on my first switch. The DHCP server has LAG setup on 2 ports with LACP enabled. The devices(pcs,laptops,printers) on the first switch all are able to get DHCP addresses from the server and are pingable.&...
I have a two-port router and external switch. One router interface is configured with the WAN information. The other interface has the LAN information, including dot1Q VLANs, and some firewall rules. Plug the LAN-side cable into a switch, configure ...
Its a ws-c3850-48tMy member 4 and 3 are stuck at syncing after power outage. Why is the config not syncing?Tried reloading and unplugging the cables.Should I remove the stack member ? Then plug the cable back in?Something like: https://vmguru.co...