In a 4500 switch with Supervisor 5 (Sup V-10GE), when active and redundant supervisor engines are installed in the same chassis, these four uplink ports are available:
In other words, two GigabitEthernet ports of the active supervisor, 1/1 and 1/2, are available as well as two of the standby supervisor, 2/1 and 2/2.
These are the reasons when two Supervisor Engine V-10GEs are present in a Catalyst 4510R or Catalyst 4507R switch:
For 10-Gigabit Ethernet Uplink Ports, one X2 uplink is active on both the primary (active) and secondary (standby) supervisor engines by default, or two uplinks are active in a nonredundant configuration.
For Gigabit Ethernet SFP Uplink Ports, two SFP uplinks are active on both the primary (active) and secondary (standby) supervisor engines by default, or four uplinks are active in a nonredundant configuration.
Hi,recently i saw this MSG. on the log file but i cant understand what is the cause route of it LC/0/0/CPU0:Feb 26 21:46:30.694 UTC: fib_mgr: %ROUTING-FIB-4-RETRYDB_NONEMPTY : One or more FIB object(s) have been in IPv4 retry queue for at ...
Hello guys,I want to ask you for help and advice regarding the QoS on private network (intranet). I have a modem form ISP connected ti my cisco router 2611xm that is connected to my switch 2950T and from there from port1(lan1 100mb/s)is connected a a...
Hello we are currently upgrading our network all c9k series and we are installing only DNA the network will be layer 3 routed access my 1st question can i use DNA to auto config my switches , or better to configure my switches manually then...
Hi all,I`m currently preparing for a certification and in the course of this I noticed that in one of my OSPF databases there are differences in the OSPF database for "Type-5 AS External Link States"! Can someone explain to me on what basis the link state...