To participate in this event, please use the button to ask your questions
This topic is a chance to clarify your questions about the configuration, verification, troubleshooting and general best current practices of dynamic routing protocols. All questions regarding to general design, flooding, in-depth mechanics, and features of RIP, OSPF, IS-IS EIGRP, and BGP are welcome.
Dynamic routing protocols are a fundamental piece for internetworking, their main function is to provide the mechanisms to generate, process, and distribute topological and network layer reachability information (NLRI). Having an in-depth knowledge of routing protocols is key to understand modern overlay solutions such as Cisco DNA and a plethora of SDN designs, since these use some form of underlying routing form to perform connections under the hood.
Ask questions from Monday 09th to Friday 20th of December, 2019
Elvin Arias is a devoted IP routing learner with a wide knowledge and experience in different technologies such as MPLS, x-EVPN, Segment Routing, IS-IS, MP-BGP, Network Programmability and Automation. He works as a Network Development Engineer in the Internet Edge Engineering team at Amazon in the EMEAR region, he focuses on Automation and R&S/SP technologies. Before that, he worked as a senior TAC engineer in the Service Provider team for the Americas theatre at Cisco. Elvin is an active member of the networking community where he often collaborates developing and publishing technical content or participating on live events or forum sessions for R&S and SP technologies for the Cisco Community, as well he engages in technical discussions in the Cisco Learning Networking community, where he has been honored with the Cisco Designated VIP distinction in multiple years 2013-2017. Elvin holds two CCIE certifications, one in R&s and one in SP (#57406)..
Elvin might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Routing community.
We have a device connected to a 3650 switch whose ethernet controller crashes when it receives more than 200000pps. The traffic to this device can have variable packet sizes, so it would not be practical for us to rate-limit by mbps. Is there an...
if we enable mls Qos command on a C3560, by default, all ports are untrusted + COS override:dis + default COS:0. if we have the below, what will be the QoS value at the egress? Untagged frame (Access port connect PC) - at egress will be COS:0???...
New to IPv6? Trying to wrap your head around concepts like IPv6 addressing, solicited-node multicast, and just how, exactly, does all this work without ARP? Never fear, Fish Fishburne is here to help with this blog series she wishes had been out there whe...
I am a novice network guy. If I have missed something obvious, please let me know. I have a N520-20G4Z-A and using SFPs only in ports 4,5,6, and 7 - Port 7 won't come up. There are no other connections to the router. The f...
I am trying to figure out an issue with Small packets (sub-200Byte) which caused firewall performance issue and so far I can only pin point to the 4507 LAN switch doing the fragmentation...Standard MTU1500 is in use though. From "show ip traffi...