Welcome to this Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and any ask questions about how to configure and troubleshoot and design network using Border Gateway Protocol with Cisco expert Vinit Jain.
Ask questions from Tuesday Janury 12 to Friday January 22, 2016
Border Gateway Protocol (BGP) is one of the most widely deployed protocols in networks today and is the definitive routing protocol in the Internet. BGP is a flexible protocol, in that a variety of options are available to network engineers. Furthermore, extensions and implementation enhancements make BGP a powerful and yet complex tool. Because of BGP's pervasive deployment across multiple networks and the large number of use-cases that BGP can be applied to, it is becoming increasingly important to understand how to troubleshoot BGP issues quickly and easily. Vinit will be helping you answer your queries on how to troubleshoot BGP
Vinit will be helping you with all your queries on all of the above.
Vinit Jain, 3X CCIE #22854 is a Technical Lead in HTTS (High Touch Technical Support) team supporting customers in areas of routing, MPLS, TE, IPv6, multicast and a wide variety of platform issues like High CPU, Memory leak, etc IOS, IOS XE, IOS XR and NxOS code base. Has been delivering trainings within Cisco on various technology as well as platform troubleshooting topics. He has also written workbook on IOS XR fundamentals on Cisco Support Community. Vinit has CCIE in R&S, SP and Sec and holds multiple certifications on programming and databases.
Vinit might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the WAN, Routing and Switching sub-community
I tried to use "secret 0" followed by an unencrypted secret. But then when I tried to access the device the password is not being accepted. In the example below - should not the password foruser skipper be foo123? username skipper pri...
Hi,I have the SG350X with inter-VLAN routing disabled. It is trunked to another switch that works as the router. No static routes are defined on the SG350X since I would like it to behave like an L2 VLAN aware SwitchWhen I try to access VLAN 1 management ...
Hello all,I am having an issue to which I have not really be able to find a cause or resolution. The OSPF neighbor relationship between 2 routers keeps dropping, then immediately reforming the adjacency.ROUTER1GW#May 13 13:35:51 EDT: %OSPF-5-ADJCHG: Proce...
Hello, I am wondering about the following scenario and if it falls under a best practice. Two locations and each location is identical in terms of equipment and purpose. Let's say location A had a vlan 100 with 184.108.40.206/24 would location B best be ...
Hello Team,I have two vEdge virtual routers in Azure and I need a server that's behind them to be publicly available. Has anyone config'd this yet? I think I have a good understanding of what I need to do but figured to throw this out there.