The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and four 1G Small Form-Factor Pluggable (SFP) or two 10G SFP+ uplinks. With FlexStack-Plus technology, the Cisco Catalyst 2960-X switches can be stacked up to 8 members with up to 80 Gbps stacking capacity for high scalability.
During this Ask the Expert Event you can ask questions about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
To participate in this discussion, please use theReply Button
Ask questions from Tuesday May 10 to Friday May 20, 2016
Santhosh Chidri Nagaraj is a Technical Leader in Enterprise Access Switching group at Cisco. He is an expert on Forwarding – 802.1X, Security, Cisco Identity, AAA, Radius, Cisco TrustSec technologies and products. Santhosh holds a Bachelor’s Degree in Mechanical Engineering from Bapuji Institute of Engineering and Technology and an MBA Kuvempu University in India. He has 17 years of experience in IT and has been working at Cisco for 5.5 years. Prior to Cisco he worked at Texas Instruments India Pvt Limited, Novell, HCL Technologies.
Prabha Ganesan is a Software Engineer in Enterprise Access Switching group at Cisco. She is an expert on Forwarding – Platform, Forwarding L3, L2, ASIC Validation as well as Catalyst Switches technologies and products. Prabha holds a Bachelor’s Degree in B.E Computer Science and Engineering from Anna University in India. She has 10 years of experience in IT and has been working at Cisco for 6.5 years. Prior to Cisco she worked at Computer Sciences Corporation.
We look forward to your participation. This event is open to all, including partners. Please Share this event in your social channels. Have a technical question? Get answers here before opening a TAC case by visiting the Cisco Support Community.
Hello All, i always find STP very confusing , however i am currently studying switching and i have the below questions:- 1-i believe that the root switch election will occur before the ports goes to any state , is that true? 2-why would the...
This document shows a list of IP protocols that are possible in the protocol field of the IPv4 header. ICMP is protocol 1, TCP is 6, and UD is 17. If I use a "permit ip any any" in a Cisco extended ACL, what protocol(s) are included in the permit statemen...
Hello friendsI'm trying to recover a fallen CPI, but I get an error of insufficient space to restore the database cpis/admin# restore cpis-190814-0330__VER18.104.22.168.550_BKSZ16G_CPU4_MEM3G_RAM11G_SWAP15G_APP_CK2872026366.tar.gpg repository FTP applicati...
Here is my Network, Have a VLAN in a switch which was connected to a Router which does BGP. If i use static route on my switch to send traffic to BGP router. I am able to ping VLAN interface ip address from other end also, i am able to ping from my e...