This topic is a chance to discuss more about the installation, provisioning, operation and best troubleshooting practices on Cisco Dense Wave Division Multiplexing (DWDM) transport systems, with particular focus on NCS 2000 series. This session will provide you with a better understanding of the installation and troubleshooting practices of the initial setup of DWDM networks, RAMAN calibration and OTDR tracing that helps to enhance quality of RAMAN installation.
To participate in this event, please use the button to ask your questions
Ask questions from Monday, April 2nd to Friday 13th, 2018
Valery Kayukovis a System Architect Engineer with over 1 decade of experience in the It industry. Currently he works as a Lead System Engineer at the Step Logic Group LLC. Valery specializes in Optical Transmission Network, SAN Networking and Storage and Computing technologies (DWDM, SDH, OTN). In addition, he has experience in network programmability particularly on C++ and Python programming. Valery holds a Bachelor’s degree in Networks and Telecommunication Systems and several certifications such as, CCNP, CCDA, CCDP and Brocade - BCFP, BCFD among others.
Carlos Amador is a Technical Support Engineer with over 6 years of experience in the IT industry. He works as a HTE and Teach Lead for the Optical accounts of Telex, Mexico’s biggest communication company. Carlos specializes in Optical Transmission Network technology (DWDM, OTN, SDH and Sonet. Before Cisco, he has worked over a decade commissioning and integrating Optical and Microwave networks in Nortel and Axtel. He holds a Bachelor’s Degree in electronics and communications engineering.
Valery & Carlos might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation at the Optical Networking Category.
Hi all, I have a new Cisco FirePower 1010 that I have configured for a small remote office. I have most of what I need working including the S2S VPN Tunnel to an ASA 5515.Now, I'm trying to get Cisco APs to lite up over the tunnel and I need to configure ...
Working on setting up a pair of 9300s to be 1 of the egress points for the network w/ a backup site at another location. Currently i have the other location using the default-information originate command w/ a metric of 5 and that works w/o any issu...
Hi I can not figure out a method to get 2 layer 3 switches which are configured with ether channel to talk to 1 router in harmoney. Non of the nodes in the VLAN 10 ,100-129 can ping the router (router ip: 10.29.0.1) i have tried ip route. Any surgest...
Hello I was wondering if anyone knew if this Router was configurable in regards to authentication vlan from the ISP.My ISP uses vlan 3163 for auth on vdsl2 whereas my ISP uses 0/32 for adsl. Was curious if this was able to be changed to that or if th...
Have you ever wondered why pluggable optics exist? Have you ever wondered what acronyms like QSFP, LR4, FEC, and PAM4 actually mean? In this first episode I start a conversation with my colleague Ray Nering. He explains to me how a lot of these came to be...