This topic is a chance to discuss more abouthow Virtual Extensible LAN (VXLAN) / VXLAN Ethernet Virtual Private Network (EVPN) works. It covers the best practices to configure, deploy and troubleshoot a Border Gateway Protocol (BGP) EVPN fabric BGP EVPN deployment and manageability can be much simpler with adequate preparation and following documented guidance. The Cisco Nexus 9000 and many other Nexus platforms has the capability to deploy VXLAN fabric with BGP EVPN.
Ask questions from Monday 14th to Friday 25th of January, 2019
Rurick Kellermannis a Team Leader of the Data Center Routing & Switching team at Cisco’s TAC in USA. He has over 20 years of experience working in the IT filed, de specializes on Routing & Switching, Services Provider (MPLS), Multicast and VXLAN technologies. Rurick holds a Bachelor’s degree in Electrical Engineering from the Universidad Autonoma de Centro America in Costa Rica.
Abayomi Adefilais a Technical Leader in the Cisco Routing Protocol technology space and is part of a team of leaders that handles escalation engagements on all routing protocols, VXLAN (EVPN), Multicast and related subjects. He has been working in the telecommunication and networking industry for the past 18+ years, with the most recent almost 9 years with Cisco. He holds a Master’s degree in Advanced Computer Networking from Glasgow Caledonian University, Scotland. Abayomi holds two CCIE certifications, one in Routing & Switching and one in Service Provider (#25926) among other industry certifications.
Rurick and Abayomi might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Switching community.
Hi everyone, This is my first post here and I'm still learning the ins and outs of the network as it was set up before I arrived. So currently I have 3 SSID's set up for the school, SGC, Staff, and Student. I have a specific AP, a AIR-CAP3702I-Z...
Hello, I have a site to site VPN from my cisco asa’s to another customer - it works fine and both tunnels can ping the remote IP address I have routing to the customer subnets from my internal Layer 3 switchsw1-Layer3#ip route 10.108.x.x 255.255...
All my other phones say 3PCC in the model number. So will these phones work? and if so, how do I clear off the previous companies settings and passcodes? Or do I need to send these back and buy 3PCC phones only?
Hi team!I configuring ASA5506X with dual ISP obtaning ip addresses with dhcp...1. does this config looking correct?2. whay ASA doesn't accept both commands. dhcp-client client-id interface OUTSIDE
dhcp-client client-id interface YOTA