Cisco Software-Defined Access is the industry’s first intent-based networking solution for the enterprise built on the principles of Cisco’s Digital Network Architecture (DNA). With SD-Access you can automate end-to-end segmentation to separate user, device, and application traffic without redesigning the network. You can also automate user-access policies to establish the right policy for any user or device, with any application, across your network. SD-Access uses a single network fabric across LAN and WLAN. The result: a consistent, highly secure user experience.
Join us for this webinar to learn how SD-Access works and to understand its use cases. You will see a demonstration on how to set up SD-Access using our centralized management dashboard, Cisco DNA Center.
I am trying to ping Loopback interface IP from PE Router in Underlay SDWAN vpn 0. But its not Pinging from either side.we are using Static Routing between PE and vEdge.is there anything special we need to do?
I have a Cisco ISR 4451-X running version 16.8.1 (Fuji) and I'm trying to configure a couple of 24-port SM-X-ES3-24-P (running 15.0(2)EJ) into it using BDI. THIS document says to use the commands below. However, in v16.8.1, #3 is not a valid command on th...
dear alli have :c2900-universalk9-mz.SPA.154-3.M1.bin" (Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.4(3)M1, RELEASE SOFTWARE (fc1)) with memory as belowCisco CISCO2911/K9 (revision 1.0) with 483328K/40960K bytes of memory.Processo...