Webcast: Cisco Catalyst 2960-X and 2960-XR Series Switches Overview, Configuration, and Troubleshooting (Live Webcast Tuesday May 10, 2016 at 10 am Pacific/ 1 pm Eastern)
The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and four 1G Small Form-Factor Pluggable (SFP) or two 10G SFP+ uplinks. With FlexStack-Plus technology, the Cisco Catalyst 2960-X switches can be stacked up to 8 members with up to 80 Gbps stacking capacity for high scalability. During this presentations, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
During this presentation, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
Comparison and differences in Cisco Catalyst 2960-X and 2960-XR Series Switches
Flex Stack Plus in 2960X/XR
Overview on various features on the 2960X/XR
Troubleshooting best practices and hints
Roopa R. is a Technical Leader in Enterprise Access Switching group at Cisco. She is an expert on Forwarding – Layer2/Layer3, QOS, Security, AVC, Netflow, and Wireless technologies and products. Roopa holds a Bachelor’s Degree in Electronics and Communication Engineering from Bangalore University and a M.S. in Software Systems from Birla Institute of Technology and Science in India. Roopa has 17 years of experience in IT and has been working at Cisco for 9.5 years. Prior to Cisco she worked at Lucent Technologies and Sasken Communication Technologies.
We look forward to your participation. This event is open to all, including partners. Please Share this event in your social channels. You have a chance to win a prize by filling out the survey after attending the live event.
Have a technical question? Get answers before opening a TAC case by visiting the Cisco Support Community.
I have 2 Nexus 5K switches that I want to make the NTP servers for my network. Nexus 1: 10.10.10.5Nexus 2: 10.10.10.6 I have read that you should only use the NTP master command if you basically plan on setting up the switches as their own...
Hello friends. I just finished configuring the Spa201R adapter. I switched from one company to another. I cannot make any calls. when I try to make outgoing calls, I receive a message saying: "That password is not valid". I don't know which password ...
I've had two different 2960X switches fail when upgrading the IOS to this version of code, while I have 50+ that completed successfully.Checksum was verified, so it's not a corrupt image. When I copied the image to these switches and reloaded, all of the ...
I'd like to use this config for EEM in the Nexus 5K. The Nexus only takes the first event syslog occurs statement so I don't understand why it's losing the 2nd statement. See below for sh run eem. Nexus 5548 version 7.0(7)N1(1). Am I violating...
Join us live on Thursday, April 2 at 10 am PT (and on demand after) as we discuss Cisco's 2020 Global Networking Trends Report about the changes that we will need to make to get our talent up to speed for tomorrow's network. Join Amanda Whaley and Jo...