This event had place on Tuesday 25th, June 2019 at 10hrs PDT
This event provides insight to the most common issues within the different Catalyst 9000 models and the best practices to troubleshoot them. The session includes tips and best practices on how to react when an issue appears, what information should be collected, and what actions should be taken to recover from such scenarios. In addition, experts introduce the new troubleshooting features that help to isolate specific broken scenarios on this platform.
Upgrades (Catalyst 9300/9400/9500 Series) and Stackwise-480 (Catalyst 9300 Series)
Unexpected reboots (Catalyst 9300/9500 Series)
Adan Acosta is a Technical Consulting Engineer on the Enterprise Routing & Switching team at the Customer Experience (CX) Center. He has worked in different areas related to network design for seven years, such as pre-sales, post sales, and technical support on Wireless, Routing & Switching, and Security technologies. Adan holds a bachelor’s degree in electronics and communication from the ESIME Zacatenco in Mexico. He holds a CCNA in R&S and Security.
Aaron Cespedes is a Technical Consulting Engineer on the Enterprise Routing & Switching team at the Customer Experience (CX) Center. He has worked with different Cisco technologies for six years, including backbone, and specializes in Switching technologies. Aaron holds a bachelor’s degree in telecommunications from the Universidad Politecnica of Costa Rica. He holds a CCNP and a CCNP in R&S certifications. He is currently pursuing a CCIE in R&S.
Hi Guys, I am getting the following error while creating the trunk link between 3650 48 ps to 3560cx-12 ps switch %PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi0/11 is not supported Have tried the commands but no luck, any suggestions ...
We split a /24 into two /25 segments:eth 1/1 - 126.96.36.199/25eth 1/2 - 188.8.131.52/25eth 1/3 - 184.108.40.206 - ISP link So the whole /24 lives on the router, but split. When I advertise 220.127.116.11/24 to ISP, it doesn't show up as and advertised route. Is there a...
This how-to is a step-by-step guide to setup a so-called TransitVNET in Microsoft Azure with CSR 1000v and Azure Internal Load Balancer (ILB).
The goal of this solution is to have a scalable and highly available way of interconne...
is it possible to add more than 1 ip wccp redirect on a vlan interface ? Each one with a different associated access list, will both redirect access list be searched for a match ? interface Vlan903ip address 10.250.1.21 255.255.255.252ip wccp 5 redir...