The event focuses on the Cisco Catalyst 9400, a leading modular enterprise switching access platform built for security, Internet of Things (IoT), and Cloud. This overview helps you to understand not only the capabilities and hardware/software differentiators of these switches, but also the new software-licensing scheme which is specific to the components and the operation of this platform. In addition, a demonstration of the usage of this platform in different case scenarios will be provided.
Catalyst 9000 Series Switches at a glance
Catalyst 9300/9400/9500 system overview
Catalyst 9300/9400/9500 system specifics
Allan Brenes is a Customer Support Engineer on the LAN Switching team in Cisco’s Global Technical Assistance Center (TAC) in Mexico. Allan has been collaborating on that team since 2016. Previously, he worked for three years as a Support Engineer with the Global Delivery Partners CSE in Costa Rica. He has experience in different technologies, but he specializes in LAN Switching. Allan holds a Bachelor’s Degree in Telematics and a CCNA certification.
David Nolasco is a Cisco Customer Support Engineer and is also part of the LAN Switching team in the Global TAC in Mexico. He has collaborated with this team since August 2014. Before he joined Cisco, David worked as a Network Engineer at Ericsson. He specializes in the Catalyst 6500, 4500, and 3850/3650 platforms. He holds a Bachelor’s Degree in Telecommunications from the National Autonomous University of Mexico. David holds a CCNP R&S certification and he is currently pursuing a CCIE certification.
I feel this probably has a obvious easy answer, but struggling a bit. PBX is 172.31.213.130 The public IPs are completely public and cinnected to our ISP.At a branch office they are setting up a PBX box that we have assigned to a vlan. But cant get p...
I've got a strange delay issue on one of our L3 switches used as a DISTRO. Distro 2 doesn't show these issues, but 1 does. Using a continuous ping from Distro1 out to devices in each VLAN I get one dropped packet after about 20-21 good ...
Hello All,I have the below topology, the OSPF neighborship is established but the default route is not being generated in OSPF Area as it's a totally stub area.Configuration as the below;N9K-SW1router ospf 1area 0.0.0.2 stub no-summaryinterface Vlan210ip ...
Hello all, I am having trouble understanding ACLs and the logic of inbound and outbound traffic. I am trying to allow network 192.168.1.0/24 to the FTPS server 192.168.3.0/24 only if an FTPS session originates from the 192.168.1.0/24 LAN. Network 192.168....
Hi there,we have a production network that uses ISIS as the underlay protocol for the MP-BGP / MPLS cloud.We have many IOS routers and two ASR-9K with IOS-XR, all of them configured in the same ISIS domain and area. All of the IOS routers are configu...