Webcast: Introduction to the Web of Things: What is it and why is it useful?
This event provides an overview of the Web of Things (WoT), from its definition and architecture, to its main components, scripting, and use cases samples. The WoT allows the integration of real-world objects not only to the Internet, but to the whole World Wide Web architecture. In this session the expert discuss the description of the architecture and main components of the WoT, which include the WoT Thing Description, the WoT Binding Templates, and the WoT Scripting API.
In addition, the expert share use cases and details about the open sources available for the WoT.
Introduction to the WoT
The WoT Thing Description
The WoT Binding Templates
The WoT Scripting API
Open source available
Ines Roblesis an Internet of Things (IoT) consultant with over a decade of experience as an IT researcher. She is the co-chair of ROLL WG, an IoT Member directorate, a member of routing directorate and a member of general area review at the IETF. Since 2014 she has been in Finland at the Aalto University to pursue a PhD related to IoT Group management. In 2007 she started as a researcher on network topics at the GridTICs laboratory UTN-FRM University in Mendoza, Argentina. She has experience with different protocols and programming.
Good Day Please advise i have switches which i have configured SVIs see below command snippet. When i try to access the switches i am not able to ssh or even ping the switches. interface Vlan1ip address 192.168.3.205 255.255.255.0!!i...
Hi, I want to create a rule for a specific port on a 3650. I want to allow all traffic within a VLAN (lets assume VLAN 10, ip address 192.168.178.254 255.255.255.0) expect for one host (lets assume ip adresse 192.168.178.100). This IP adre...
Hi,I need to extend a temporary switch inside our network. There is no need for SGTs/Segmentation and my only requirement is to extend a VLAN on a new switch and have hosts plug into the new switch. From my understanding, this should just be a ...
I saw the following statement in the document below. [document]'https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/layer-2-switching/configuration/guide/b-cisco-nexus-9000-nx-os-layer-2-switching-configuration-guide-93x/b-cis...
Hello, I am configuring remotely some switches 9500For this a laptop is connected to the Console port of the switch.Console port opens fine using standard values from Putty Terminal. But when the terminal has to show several lines, the laptop crashes, reb...