New to Cisco

[NathanLKoch]

Hello,

I am entirely new to Cisco hardware and my level of understanding regarding Enterprise Networking is pretty low. I recently purchased a ISR, a large Switch, and a Aironet AP. I also went to my local Library and picked up some CCNA books. I have been watching Youtube videos as well.

Here we go.

[ChuckMcF]

Good luck with your journey!

Chuck

[NathanLKoch]

https://www.youtube.com/watch?v=FjjBHY7sZo4

[jeroen.devroede]

Hey Nathan,

As I am preparing for CCNA, I did the exact same thing...Cisco 48p SSG switch with PoE, Cisco ISR router with 4G fallback, and a WAP121 AP.

Was fully working last nite, but then, when setting up the primary WAN and secondary WAN, made a mistake and lost all ip4 communication.

If you can share your running conf, would be interesting

Good luck

Jeroen

[NathanLKoch]

From an Op Sec perspective. It's not entirely the best Idea to share my full configure files. I would recommend routinely backing up your config files.