Community Live- New Additions to the Catalyst 8000 Family
(Live event - Tuesday, 23 February, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event had place on Tuesday 23rd, February 2021 at 10:00 hrs PDT
Designed for an intent-based network, the Cisco Catalyst 8000 Edge Platforms family offers best-in-class networking and security combined. The platforms, available in both on-premises or virtual options, are designed for accelerated SD-WAN services, multilayered security, cloud-native agility, and edge intelligence to accelerate your journey to the cloud.
Overview of the Catalyst 8000 Edge Platforms family (C8300, C8500, and C8Kv) already launched
Introduction to Catalyst 8200 and 8200 UCPE Series edge platforms as new additions
Key building blocks
Platform hardware and software architecture
Product comparison between ISR4331 vs. C8200 and ENCS5100 vs. C8200 UCPE
Solutions and use-cases
Ramesh Kalimuthu is a Technical Marketing Engineer for SD-branch solution and uCPE products in EN Routing. He has 20+ years in networking and is thankful for the fun learning experience in delivering best in class products in routing, security, and the collaboration space. He is passionate about creating and driving the adoption of new technologies, with SDN and Virtualization solutions as his current focus.
Shameel Ummer is a Technical Marketing Engineer for ISR 4000 as well as Catalyst 8300 Series. Shameel is 4X CCIE and is responsible for all things crypto on the routing platforms
Switch runs RSTP (via MST setting) and it shows that one of its uplinks is in "BLK" status, as expected and another uplink is in "BKN", which is not expected and cuts this switch from the network. This switch runs with Aruba switches, which run RSTP spann...
We migrated from Cisco ASA 5585 version 9.8 to FTD 2130 version 6.2.We recently upgraded to 6.7 on the FTD.The ASA had manually configured class maps, one addressing embryonic and half closed connection timeouts.We upgraded the FTD/FMC on the 27th o...
Hello, I have a large multicast environment that is kind of all over the place on how PIM is configured. Some interfaces are sparse, some are sparse-dense, and some are passive (none are just dense). I have been moving to standardized my config such ...
-I had a c9200 device discovered by dna center and it showed a cli authentication error. -tried to delete it from inventory and I checked clean up configuration box. -and then I did a reset the device configuration. -but the device didn't r...
We have a ISR4331 that we use as a voice gateway. Currently it is on version isr4300-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin and it works without any problems. After the upgrade it doesn't even initialize the call I ran a kron debug and found ...