I have single router connected with 2 different ISP. One link is 10G interface 1 and another link is 1G interface 2. Can I control all incoming traffic 70% via interface 1 as this is 10G link and 30% traffic incoming via interface 2 as this is 1G link. Is...
view more
DearsPlease check below , in my switch 9200 is loosing configuration once restart the switch , this issue started only after upgraded ios. FF-SW1#show boot---------------------------Switch 1---------------------------Current Boot Variable...
view more
Hello Cisco Team, Hope you are doing good. Could you please advise how to generate graphs for a network in Cisco Packet Tracer ? Awaiting for a response. Regards,Azhar
Hi! I´m receiving the error Failed to commit one or more configuration items during a pseudo-atomic operation. All changes made have been reverted. Please issue 'show configuration failed [inheritance]' from this session to view the errors.I received this...
view more
Dear all, May I know if the "system mtu jumbo" command will appear in the "show running-config" of a CGS2520 switch please? Or it will be hidden from the IOS config files? Thanks for your attention in advance!