Live Webcast: Get Ready for the World I... - Cisco Community

783

Views

0

Helpful

0

Comments

(view in My Videos)

This session sheds light on the upcoming “World IPv6 Launch” and how you can plan for it. During this live event, Cisco subject matter expert Salman Asadullah focused on IPv6 deployment techniques in core networks and Q & A was answered by a panel of distinguished engineers and experts from Cisco.

Webcast related links:

Slides
FAQ

You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.

Comment

Latest Contents

Regular DHCP Binding Output

Created by hillda01 on 09-20-2019 05:17 AM

0

0

0

0

HiI want to output the dhcp binding information using a krontab every 1 hour but I can't see to work out the krontab schedule for hourly or the krontab won't do an hourly output. This is the command that I've got and it works but I want it to run eve... view more

DNAC interface subnet size and switch-side config

Created by Csaba Nagy on 09-20-2019 05:06 AM

0

0

0

0

What's the minimum recommended size of the DNA-C 10G interface subnets? A /28 for each interface should be more than enough allowing enough addresses for all 3 nodes including the VIP addresses too, shouldn't it? In case of M4 appliance the swi... view more

Created by Behnam.Ghasemiyeganeh on 09-20-2019 04:47 AM

1

0

1

0

I have a question.I have a Switch 3650 with the firmware 16.3.6.its Port 48 is connected to an AP ,after some time[could be months ] start to drop the packet.but this problem is only with this interface. if i connect the AP to another port of switch ... view more

prime infrastructure 3.7 device import failure

Created by JON SHORTEN on 09-20-2019 04:28 AM

0

0

0

0

Trying to import a list of c360 devices after upgrading; file is accepted by import process, but the import job fails with no reason given in the detail screen. Can anyone point me at where to start troubleshooting this please?

Netflow and EIGRP traffic

Created by NicolasDemonty on 09-20-2019 04:14 AM

0

0

0

0

HiI configured flexible netflow on cat6k with sup2t and I was wondering whether eigrp is considered as flows ? Actually I configured netflow on an interface that is part of a p2p link where EIGRP is running. I'm a bit surprised to not get the eigrp hello ... view more

CreatePlease to create content