The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and four 1G Small Form-Factor Pluggable (SFP) or two 10G SFP+ uplinks. With FlexStack-Plus technology, the Cisco Catalyst 2960-X switches can be stacked up to 8 members with up to 80 Gbps stacking capacity for high scalability. During this presentations, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
During this presentation, Roopa R. will talk about the architecture and stacking of the Cisco Catalyst 2960-X and 2960-XR Series Switches. She will also cover packet walk through, overview, configuration and troubleshooting of various features on these switches like QOS, Security, Netflow, PnP etc.
Comparison and differences in Cisco Catalyst 2960-X and 2960-XR Series Switches
Flex Stack Plus in 2960X/XR
Overview on various features on the 2960X/XR
Troubleshooting best practices and hints
Roopa R. is a Technical Leader in Enterprise Access Switching group at Cisco. She is an expert on Forwarding – Layer2/Layer3, QOS, Security, AVC, Netflow, and Wireless technologies and products. Roopa holds a Bachelor’s Degree in Electronics and Communication Engineering from Bangalore University and a M.S. in Software Systems from Birla Institute of Technology and Science in India. Roopa has 17 years of experience in IT and has been working at Cisco for 9.5 years. Prior to Cisco she worked at Lucent Technologies and Sasken Communication Technologies.
Have a technical question? Get answers before opening a TAC case by visiting the Cisco Support Community.
Hello, I am able to update an existing access-list standard or extended using templates in prime infrastructure 3.7.However when I try to remove the entry I get errors.My template:ip access-list $ACLType $ACLNameno permit $Device1no permit $Device2e...
Hello Cisco CommunityWe are building a new DNAC and facing some issues. configuration as followsAppliance model : DN2-HW-APL-XLSoftware Version : Version 188.8.131.52Enterprise IP / enp69s0f0: 10.18.4.85 with Default gateway Cluster Subnet IP / ...
Hello All, - I have a lab setup where there is 3 WAN edges: (ISR4331, vEdge cloud & CSR1000v)- I did upgrade vManage to 184.108.40.206 and both vSmart and vBonds to 20.3.2- upgraded vEdge cloud to 20.3.2- upgraded ISR4331 to 17.3.2- CSR1000v has IOS of...
Hello Group, I have a pair of 4331 ISR routers connected together. Each router is connected to a WAN interface, one active the other standby. I have EIGRP running out of the WAN interface. I want to prefer the active WAN interface, over the standby in EIG...
Hello,we have a small network with some c9200 switches and a lot of VLAN there.Now, some days ago a network expierenced guy told us, that using VLANs could be dangerous because of VLAN hopping. I am not very common in that because we declare all ports as ...