Dear all, May I know if the "system mtu jumbo" command will appear in the "show running-config" of a CGS2520 switch please? Or it will be hidden from the IOS config files? Thanks for your attention in advance!
I have a simple scenario as in the diagram:I am advertising a route 40.40.40.0/24 from R4 to AS 100. When I verify BGP table in the R1,R2,R3:R1#show ip bgpBGP table version is 8, local router ID is 1.1.1.1Network Next Hop Metric LocPrf Weight Path* i...
view more
Thought just occured to me as to whether or not I should be able to ping acorss this trunk portswhile doing this lab In doing a HSRP lab between the switches I recognized there needed to be communication between the switches to elect the active...
view more
Hi All I have 2 x Cisco 1140 Fws running in ASA mode. Active/Standby 2 x 9300s with a trunk between ten Cisco have depreciated the Redundant interface on the 1140s I have configured sub interfaces on one of the ports of FWs with ...
view more
Dear All,
Can I point all switches to one querier in the l2 multicast network? Attached is the sample topology with each device config pointing to one switch NXOS1, which is the querier, or other devices will discover the querier NSOX1 vi...
view more
