cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2265
Views
5
Helpful
2
Replies

Multicast supported over Nexus 7k?

craneman1
Level 1
Level 1

I am hearing that multicast is not supported over the Nexus switches like the 7k with vpcs? Is this true? Thanks for your comments or tips...

1 Accepted Solution

Accepted Solutions

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi @craneman1 

If by multicast over vpc, you mean multicast routing, then you should check this document:

https://www.cisco.com/c/en/us/support/docs/ip/ip-routing/118997-technote-nexus-00.html

You will see it's mentioned that

  • For all Nexus platforms, a PIM adjacency over a vPC or a vPC orphan port is not supported. To form a supported PIM adjacency, you must have a Layer 3 connection from each Nexus switch to the relevant PIM router or form the PIM adjacency over a non-vPC VLAN.

However, you can have PIM adjacency over vPC Peer-link.

If on the other hand, you are refering to L2 multicast and/or IGMP snooping, then this one is supported. For more details about it you can check the config guide:  https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/multicast/config/cisco_nexus7000_multicast_routing_config_guide_8x/m_igmp_snooping.html

 

Stay safe,

Sergiu

 

 

 

View solution in original post

2 Replies 2

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi @craneman1 

If by multicast over vpc, you mean multicast routing, then you should check this document:

https://www.cisco.com/c/en/us/support/docs/ip/ip-routing/118997-technote-nexus-00.html

You will see it's mentioned that

  • For all Nexus platforms, a PIM adjacency over a vPC or a vPC orphan port is not supported. To form a supported PIM adjacency, you must have a Layer 3 connection from each Nexus switch to the relevant PIM router or form the PIM adjacency over a non-vPC VLAN.

However, you can have PIM adjacency over vPC Peer-link.

If on the other hand, you are refering to L2 multicast and/or IGMP snooping, then this one is supported. For more details about it you can check the config guide:  https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/multicast/config/cisco_nexus7000_multicast_routing_config_guide_8x/m_igmp_snooping.html

 

Stay safe,

Sergiu

 

 

 

Thanks very helpfull and I think we might need to upgrade to version 8!