cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2264
Views
5
Helpful
2
Replies

Multicast supported over Nexus 7k?

craneman1
Level 1
Level 1

I am hearing that multicast is not supported over the Nexus switches like the 7k with vpcs? Is this true? Thanks for your comments or tips...

1 Accepted Solution

Accepted Solutions

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi @craneman1 

If by multicast over vpc, you mean multicast routing, then you should check this document:

https://www.cisco.com/c/en/us/support/docs/ip/ip-routing/118997-technote-nexus-00.html

You will see it's mentioned that

  • For all Nexus platforms, a PIM adjacency over a vPC or a vPC orphan port is not supported. To form a supported PIM adjacency, you must have a Layer 3 connection from each Nexus switch to the relevant PIM router or form the PIM adjacency over a non-vPC VLAN.

However, you can have PIM adjacency over vPC Peer-link.

If on the other hand, you are refering to L2 multicast and/or IGMP snooping, then this one is supported. For more details about it you can check the config guide:  https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/multicast/config/cisco_nexus7000_multicast_routing_config_guide_8x/m_igmp_snooping.html

 

Stay safe,

Sergiu

 

 

 

View solution in original post

2 Replies 2

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi @craneman1 

If by multicast over vpc, you mean multicast routing, then you should check this document:

https://www.cisco.com/c/en/us/support/docs/ip/ip-routing/118997-technote-nexus-00.html

You will see it's mentioned that

  • For all Nexus platforms, a PIM adjacency over a vPC or a vPC orphan port is not supported. To form a supported PIM adjacency, you must have a Layer 3 connection from each Nexus switch to the relevant PIM router or form the PIM adjacency over a non-vPC VLAN.

However, you can have PIM adjacency over vPC Peer-link.

If on the other hand, you are refering to L2 multicast and/or IGMP snooping, then this one is supported. For more details about it you can check the config guide:  https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/multicast/config/cisco_nexus7000_multicast_routing_config_guide_8x/m_igmp_snooping.html

 

Stay safe,

Sergiu

 

 

 

Thanks very helpfull and I think we might need to upgrade to version 8!

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:


This community is intended for developer topics around Data Center technology and products. If you are looking for a non-developer topic about Data Center, you might find additional information in the Data Center and Cloud community