03-14-2022 05:24 PM
Guys,
I am facing an issue in the N7K where I trying to configure the ip dhcp relay address X.X.X.X on a VLAN interface, but I getting the following error message:
ERROR: hardware programming failed. Reason: Tcam will be over used, please enable bank chaining and/or turn off atomic update. If bank-chaining is enabled on other modules and this is a new linecard insertion, please enable bank-chaining prior to reloading this module.
Thanks!
Solved! Go to Solution.
03-14-2022 05:52 PM
03-14-2022 05:52 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
This community is intended for developer topics around Data Center technology and products. If you are looking for a non-developer topic about Data Center, you might find additional information in the Data Center and Cloud community