Upgrading a pair of N9K-C93180YC-EX

[rpidcock@bankrcb.net]

Planning to upgraded these switches from 7.0(3)I7(8) to new 9.3.7.  Would like to confirm if I can perform this upgrade in a single jump.  If I'm understanding documentation correctly I should be able to do this.  Can anyone confirm.

Upgrading from a 7.x release to a 9.3(x) release may require more than a single hop. The following section
describe the upgrade paths required.

The following are the upgrade paths from previous 7.0(3)F3(x) releases:
• Release 7.0(3)F3(x) -> Release 7.0(3)F3(4) -> Release 9.3(x)

[balaji.bandi]

there are some known issue and caveats when you upgrading from 7.X  to 9.3 check is this effects your environment.

if you have test device i would suggest to test in that before you upgrade live if that feature effecting you.

https://jerome.pro/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/upgrade/guide/b-cisco-nexus-9000-nx-os-software-upgrade-downgrade-guide-93x/b-cisco-nexus-9000-nx-os-software-upgrade-downgrade-guide-93x_chapter_0111.html

[rpidcock@bankrcb.net]

Thanks for the info.  I did proceed to perform the upgrade and the upgrade was successful with no issues.

Thanks again.

Richard

[balaji.bandi · Accepted solution]

Good to know all went well. can we mark this as solution if this is completed.