We are proud to announce the release of the latest version of the Cisco VNF MANO solution, including Cisco NSO Network Function Virtualization Orchestrator (NFVO) 4.2 and Cisco Elastic Services Controller (ESC) 5.1. These are used in many of our NSO customers' networks, and have been demonstrated as interoperable with more than 50 VNF types from more than 20 vendors.
These latest versions introduce the following new features: * Support for VMware vCenter * NSD editor. Create or edit a network service descriptor (NSD) compliant with the ETSI SOL006 standard * Kubernetes CNF orchestration POC. Lifecycle management of Kubernetes as a VM on Openstack, and lifecycle management of CNF. * ETSI SOL002 interface between VNF EM and ESC * High availability features, including active-active, where three instances of ESC share the load and recover gracefully in the event of an instance failing. Also support for a second, geographically separated active-active cluster. * Distributed monitoring, to enable centralized ESC instances or clusters to manage VNFs in remote locations in a reliable and scaleable fashion * Multiple VIM types managed by a single ESC instance or cluster.
It would be appreciated if someone explained the NSO behavior described below to me. I am deploying a service instance which enables interface SVI on Cisco Neuxs, which causes the device to enable 'Vlan 1' SVI - this one is, however, not explicitly c...
I downloaded and installed the nso-5.3 installer for Linux. I followed the instructions up to source /opt/ncs/ncs-5.3/ncsrc. So far so good. I created the directory/opt/ncs/ncs-5.3/ncs-runThe next step isncs-setup --dest /opt/n...
Hi, I have been trying to use Navu under /scheduler:scheduler/scheduler:task to iterate on the names as part of a helper function that sets an action-param based on the current date-time. None of that really matters except for the part where t...
We have a requirement for DB backup and restore.
Exploring the forum I found 2 options
1) ncs-backup: This is applicable only for system-install. We are using local-install.
2) ncs_load: This take the config backup in cli/xml format....