cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
73
Views
2
Helpful
2
Replies
Beginner

Custom configuration in NSO-managed block

Hello community,

I've created a NSO infrastructure service which pushes the basic BGP configuration to my devices, and establishes the needed interior peerings between them.

On a few devices, I manually added external BGP neighborships.

What can I do to prevent the infrastructure service from removing these manual sessions when it is re-deployed? Without modelling these BGP sessions in the service if possible.

Thank you,

Sylvain

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: Custom configuration in NSO-managed block

Hi Sylvain,

In general, NSO should only remove what it added unless you explicitly tell it to delete something.

-Dan

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Re: Custom configuration in NSO-managed block

Hi Sylvain,

In general, NSO should only remove what it added unless you explicitly tell it to delete something.

-Dan

View solution in original post

Highlighted
Beginner

Re: Custom configuration in NSO-managed block

Hi Dan,

Thank you. Thanks to your response I understood the behavior I was observing was wrong. Probably some old dependencies due to successive code upgrades. I've cleared the configurations and re-deployed the current packages, and it's now working as expected.

Sylvain