cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
801
Views
2
Helpful
3
Replies

netsim multi-ned network issue

previousqna
Level 5
Level 5

Hi All, 

 

I am trying to create a netsim network of ios and iosxr devices, however nso is only able to see devices of one type.

 

I am using nso 4.2 and create an iosxr network using ncs-netsim create-network command. Next I use the add-to-network command and add ios devices followed by ncs-setup and ncs to start nso.

 

When I connect to the devices I only see the iosxr devices which I created via the ‘create-network’ option. 

 

Not sure why I don’t see the ios devices in nso even though they are visible in the netsim directory and I can cli-i connect to them?

 

1 Accepted Solution

Accepted Solutions

And better, with NSO 4.2, you should be using NSO projects:

 

ROGAGLIA-M-M0VW:~ rogaglia$ ncs-project —help

View solution in original post

3 Replies 3

previousqna
Level 5
Level 5

Looking at the netsim man page you should be doing the following to load the netim devices into the ncs db

 

$ ncs-netsim ncs-xml-init > devices.xml
$ ncs_load -l -m devices.xml

Thanks, that works.

 

I was following the getting started guide which doesn’t work for this case.

And better, with NSO 4.2, you should be using NSO projects:

 

ROGAGLIA-M-M0VW:~ rogaglia$ ncs-project —help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the NSO Developer community: