Have NSO with FMC device registered - using via CLI (for testing only) - all working fine.
I wanted to use restconf for my application.
But i do not see and process listening on tcp/8080:
Also config file looks like this:
Pretty default/standard install.
Why there is no webgui nor restconf ? What do i miss ?
Solved! Go to Solution.
Thanks for the help here.
It looks like we have no process listening on 8080.
the same also with lsof:
telnet gives the same result as curl.
Should it work out of the box ? Or maybe there is something i should configure after deploying NSO ?
(when i was playing in the lab with the old NSO version, around 4.1-4.2 i had web interfaces and did not remember to install anything extra, it was out of the box).
Now with 4.6.2 it is not....
This depends entirely on your ncs.conf file. If you are running any of the NSO examples, then yes, the webui would be enabled out of the box. Did you change the ncs.conf file after starting NSO? If so, "ncs --reload".
On my system "lsof -n" calls 8080 "http-alt":
ncs.smp 57089 jlindbla 92u IPv4 0xca5b712a925f347d 0t0 TCP *:http-alt (LISTEN)
Yes - this is default 4.6.2 install, no changes to nso.conf, very default install. And i can confirm no process listening on tcp/8080. ncs --reload did no help.
I will open a TAC case for this and update you here on the results.
Hi Viktor, Team
Thank you for the help here.
I have opened TAC case 685381128.
ncs --reload did not help but....
After we rebooted whole VM the problem is gone. We can see process listening on tcp/8080.
Certainly some problem here.
Will keep in monitoring status for 1 week.