CISCO 9200L 24p, changed packages.conf

[chrsphr]

Hi, i tried to roll the switch back to an older version than 17.09.01r. So i copied in the new packages.conf but forgot to put in the new .pkg files. So when i reloaded the switch i get stuck inn rommon mode. I've tried to boot from USB with both the old packages.conf file and with a different .SPA.bin file (i do not have the .bin for the same version available), but the SPA.bin file stops on the exact same place each time (see pictures). Factory reset/power cycle have been tried many times. Also tried to change the "set BOOT=XX" variable to the USB. "Emergency-install" is not a supported command. Also tried with different USB's with (FAT16) some over 16GB and some lower. Still no change.

Does anyone have a solution?

[Leo Laohoo]

IF this is a 9200L, why is someone forcing the 9200L to boot a firmware meant for a 9300/9400/9500/9600?

Post the complete output to the command "dir flash:".

[chrsphr]

At the time we did not have access to the 9200L firmware...

I have the original packages.conf (4915bytes) on a USB.. 

[Leo Laohoo]

If the firmware is in the USB flash drive, then post the complete output to the command "dir usbflash0:".

FYI:  All software download for all Catalyst 9k switches are FREE.

[chrsphr]

 

[Leo Laohoo · Accepted solution]

Download the files legally and for free:  https://software.cisco.com/download/home/286320042/type/282046477/release/Cupertino-17.9.5

[chrsphr]

after a lot of waiting it worked. 

Thank you for your help! 

Have a nice day!