I am using KEPSERVER SNMP to develop a faceplate for network switchesCan someone tell what OIDs I can use or try for checking if an SD card is inserted or present in STRATIX or Cisco switch. I am also after OIDs for detecting SD Card Alarm, License e...
I have a number of switches in my Smartcare Portal SNTC that show as not recognised "SNAS validated data not available" They are all valid Cisco Switches why would this be happening ? Thanks
So I chose a PT-Switch-Empty and I added the ports to it. All the port numbers are coming up inverted? Why is this? Ethernet0/1 unassigned YES manual down downEthernet1/1 unassigned YES manual down downEthernet2/1 unassigned YES manual down downEther...
Hi Everybody,New user here. Has anyone ever seen this error email before (from reserving a time slot for Meraki Enterprise): Your reservation <url removed> is not started due to "errors":["Email is already in use by a SAML SSO user."].Please check ...
Hi,
I'm trying to spec out an upgrade of a couple of NCS 5508 routers, and trying to figure out whether or not the 400G line cards I'm considering requires more power supplies to be installed.
However, the CPC does not include any of the newer hard...
Hello,I am trying to find the for Cisco Smart Software Manager On-Prem solution what are the required internet URLs. Could you please advise if this is mentioned in any article/whitepaper/installation guide ? Regards,Vlad
Hello, I am quite stuck on configuring a fully specified static routing on both routers on this packet tracer problem, I always get "Inconsistent address and mask". If anyone could guide me in configuring fully specified static routing, that would be...
I have a problem with the display of packet tracer 8.0.As you can see in the picture, the display is very pixelated, which on its own would not be that great of a problem. In the second picture you can see that when pressing a device, the pop-up wind...
hello
I am trying to update my CSCO# under the self service portal
the session hangs each time I attempt
I used Chrome & Edge with the same results
Q has anyone come across this issue ?